EOS Invisio Midi, Инструкция по сборке и эксплуатации

Страница: 33 / 57

33 EN
Fig. 6
fastening screws
water splash funnel
silicone hose
connector tube
bench apron
Installation example
Fig. 5
5. Mount the air deflector
Mount the air deflector back on the heater. Pay
attention that the reclining panel shall face away
from the rear wall and the hot air exit shall be
under the 10 cm gap between the sauna wall
and the screen panel. Fasten it with 5 screws.
Please move off the safety film from the unlac-
qered version.
6. Install the water-splash funnel
• Insert the supplied connector (angled tube
piece) into the hole above the gutter on the
side wall of the heater. Make sure it sits tightly.
• Mount the funnel at the suitable place to the
sauna wall or partition wall with 2 screws.
• Pay attention that the funnel should be placed
well above the gutter level.
•
!
The mounting place of the funnel
should exclude the risk of its accidental
touching because it may be very hot! Risk
of burning!
• Connect the funnel and the connector with
the silicone tube. The tube should decline to
the connector, the contact with the heater
must be avoided.
4. Mount the water infusion gutter
The gutter may be mounted in two ways by
turning it around (fig. 5) in order to allow the
connection of the water supply hose from the
left or from the right side.
Choose the side where the water supply for later
water infusion shall be connected to and insert
the gutter accordingly, so that it declines from
the water connection point to the opposite end.
Fasten the gutter with 2 screws 4,2 x 9,5 per side
to the side panels of the air deflector (fig. 5).
Fig. 4
Rock store