background image

3

GB

Risk of fi re if assembled incorrectly.  

Please read these assembly instruction 

carefully though and retain it for further refe-
rence. Take special note of the advised safety 
gaps and the following notes.

•  The infrared radiator is designed for 230 V 

50 Hz voltage.

•  Assembly and connection to the timer unit 

must be carried out in accordance with the 
connection diagram.

•  Before  the  radiator  is  switched  on,  check 

that all connections are secured and tighte-
ned properly with no risk of getting loose.

•  The EU 60335-2-53 (VDE  0700 Part 53) 

regulations shall be complied with.

•  Notice  that  the  main  energy  discharge  in 

the unit occurs through the infrared radia-
tion. 

•  Take care to ensure that the IR radiator is 

not  exposed  to  any  mechanical  stresses 
(hits, tension, pressure). Risk of damage. 

•  Although breakage is unlikely when the ra-

diator is used properly, if it is nevertheless 
broken or damaged, don‘t use it anymore. 
Replace it with a new one.

Caution:  fi re  risk  in  the  case  of  a 
broken radiator.

  

Important notes

In the case of any skin disease or illness, 
make  sure  to  consult  a  doctor  before 
use.

• 

This  device  has  not  been  designed 
for  being  used  by  persons  (including 
children) that are physically or mental-
ly handicapped or have sensory disabi-
lities. Furthermore, it is not allowed to 
use this device without suffi cient expe-
rience and/or knowledge, unless these 
persons will be supervised by persons 
responsible for their security or in case 
they  have  been  instructed  how  to  use 
this device.

•   Children  are  not  aware  of  the  dan-

gers which may occur when operating 
electrical  appliances.  Children  must 
therefore  never  be  allowed  to  operate 
electrical  appliances  without  adult  su-
pervision.

•  Do not use the appliance in bath rooms, 

rooms with high humidity or near swim-
ming pools.

•  The  tanning  system  must  be  installed 

in a dry room and kept free of exposure 
to spray or drop moisture.

•  When installing the IR radiation system, 

please ensure that the ceiling has suf-
fi cient  load-bearing  capacity  (min.  70 
kg).  If the capacity is lower, the ceiling 
has  to  be  reinforced  and  the  installer 
must furnish appropriate documentati-
on.

•  Relative  air  humidity  of  max.  70%  as 

well as  room temperature from 15 °C to 
28°C shall be observed.

•  Do  not  switch  on  the  unit  in  any  area 

which may contain explosive vapours. 

Always disconnect the system from 
the power source when performing 
works on the system (servicing or 
cleaning operations). 

  Repairs to the IR radiator may be carried 
out only by 

a qualifi ed electrician or by plant 

customer service personnel.

Never look directly at the IR radi-
ator for a longer time, as it may 
cause risk of eye damage. Always 

wear a special eye protection goggles.

This unit is not a medical device designed 
for medical purposes in the sense of the 
German  Medical  Products  Law  (MPG). 
This unit shall not be used for medical 
purposes.

Содержание InfraSky 3000










Отзывы: