7
Ô
housing
red
red
sensor
board
hole
sensor housing
sauna ceiling
center sensor housing
on middle section
sensor line
terminals in the
control unit
Illust. 11
5. After you are finished installing and have
made sure the control unit is functioning
properly, check the line for overheat
shutoff protection for short circuits. To
do this, release one of the white lines in
the sensor housing. The control unit's
safety relay should now fall, i.e. the
heating circuit should now be
interrupted.
Illust. 12
Ç
LED display
heating (red)
Å
display for
humidity level
Æ
LED display
operational (green)
button for decreasing
value
Ã
button for CLIMA-
mode
Ä
Á
temperature
selection
À
function
selection
button for
increasing value
Â
Illust. 10
2. Drill a hole to lead the cable through,
preferably through the middle of one of
the wooden boards.
3. Lead the sensor cable through the drilled
hole and attach it to the sensor line
according to Illust. 11.
4. Attach the lines for the shutoff (white) and
the temperature sensor (red) according
to Illust. 10 to the sensor board. Then
insert the sensor board into the housing.
shutoff sensor
Sensor
white
(Limiterf)
white
(Limiter)
english
