EOS ECON 45A2, Инструкция по сборке и эксплуатации

Страница: 26 / 59

26 GB
3
Assembly of the control unit
Wall mounting
Mount the control unit outside the sauna
cabin only. The most practical mounting point
would be the wall area onto which the sauna
oven is mounted on the inside, except on the
outside of the cabin. If electrical conduits are
present, mount the control unit accordingly.
To mount the control unit, please follow these
instructions:
Fastening screws
Illust. 1
1. Remove the cover of the control unit. Loo-
sen the fastening screws below the cont-
rol panel. If your unit uses control knobs,
remove them. Enlarge the holes for the
electrical cables (Illust. 4) with a sharp kni-
fe. Drill the threaded holes for the inclu-
ded 4 x 20 mm wood screws according to
Illust.s 3 & 3.1.
2. Insert one of the wood screws into the
upper middle hole. This screw will be the
mounting point for the control unit. Make
sure the screw is projecting out about 3
mm. (Illust. 3.2)
3. Hang the control unit onto the 3 mm pro-
jecting screw. Lead the electrical cable
through the holes you enlarged in step 1
and screw the lower part of the housing
onto the cabin wall using the lower threa-
ded holes. (Illust. 4)
eye level
eye level
Illust. 3
Illust. 3.1
Illust. 3.2