15
Maintenance And Service
c
ast
D
ooR
R
emovaL
:
Figure 17. Top latches for glass door (louvers removed)
Figure 18. Bottom Alignment Slots for glass door
Door Latch Mechanism
Door Tool Hole
Alignment Slot
(both corners)
*Parts removed
for clarity*
In order to install the log set, and
for regular cleaning, the glass door
must be removed. The cast door
must first be removed, as outlined
in the section above, before
accessing the door latches. There
are two (2) door latch mechanisms
on top the glass door as shown
in Figure 8. Each latch has a hole
at the front to use the door tool,
supplied with the unit, to pull the
mechanisms straight out and up.
When the top latches are unhooked,
lean the door forward and then lift
it up out of the alignment slots at
the bottom corners of the firebox,
shown in Figure 18.
To replace the glass door, simply
reverse the above procedure.
Warning:
Do not touch or attempt
to remove the glass door if the
fireplace is not completely cold.
WARNING: Never operate the
fireplace with the glass door
removed.
g
Lass
D
ooR
R
emovaL
:
Louvers
Cast
Door
The cast door on the S30I needs to be removed
whenever access to the firebox is required.
First, remove the bottom two louvers as shown
in Figure 16 by lifting up and out. The cast
door, with safety screen and ash lip attached,
can now be removed be lifting up and out. Lay
the door face down on a towel or blanket to
prevent scratching the finish. To re-install the
cast door simply reverse the procedure.
Figure 16. Cast Door Removal
