31
Figure 44. Install Fan Controller.
Figure 45. Install Fan
Controller Nut.
Secondary Installation
5. Slide the fan temp sensor in place under the holding tabs above the SIT valve (see Figure 43).
6. Remove knob and nut from the fan controller. Place the knob stud through the fan hole in the control
panel, the controller tab should align with the control panel hole (see Figure 44). Tighten the nut on
the front side to keep the fan controller in place (see Figure 45), then install the knob onto the stud.
7. Use marrettes or approved connectors to connect the fan harness wires to the house wiring.
8. Re-install the control panel wiring and control panel.
Figure 47: Move Back Stand-
Off.
Figure 48: Installing Fan Through
the Back.
O
PTIONAL
F
AN
K
IT
I
NSTALLATION
T
HROUGH
B
ACK
OF
R
ETREAT
:
1. Use a flat head screwdriver or a 1⁄4” socket to remove the six (6) screws securing the back cover (see
Figure 46).
Figure 46: Removing Back Plate From Retreat.
Figure 43: Installing Temperature
Sensor.
2. Remove the two
(2) bottom screws
securing the stand-
off (see Figure 47)
and swing it out of
the way.
3. Install the two (2)
grommets;
place
a 8-32 x 3⁄4” bolt
through
each
grommet,
then
screw the bolt to the back cover using
a 1⁄4” socket.
4. Ensure the wiring harness is attached
to the fan then hook the two (2) slots
on the fan box over the grommets
installed in the last step.
5. Slide the fan and wiring harness
assembly into the hole in the back
of the Retreat, motor side first (see
Figure 48).
6. Re-install the back cover and the stand-off screws.
7. Remove the two (2) screws holding the control panel in place. Disconnect the sparker and rocker
switch wires, and remove the panel.
8. Slide the fan temp sensor in place under the holding tabs above the SIT valve (see Figure 43).
