ENVIRCO Control Console
Operation Manual
5.4.
User Monitor Mode
If any dial activity is detected, the Control Console leaves standby monitor mode and
enters user monitor mode. In this mode, any unit can be selected by rotating the Select
dial.
Figure 3: User Monitor Mode Front Panel Functions
Note: If the Select dial is moved past the valid address range, the select display shows
"OP". Pushing the Select dial enters the Option Menu.
Page 10
5.5.
User Adjust Mode
This mode is identical to User Monitor mode, except that the set speed of any motor can
be adjusted.
Address
Set Speed
No Effect
Rotate to select address.
Press to lock selection.
Pressure Switch Status
Address
Set Speed
2. Adjust Set Speed
Up or Down.
1. Rotate to select address.
Pressure Switch Status
Figure 4: User Adjust Mode Front Panel Functions
If the Select dial is moved below the valid address range, the select display shows "OP".
The current access level is also displayed. Pushing the Select dial enters the Option
Menu.
The Control Console writes the set speed as a percentage of the maximum speed (0-
99%). If power fails, each Digital Speed Controller will run at the most recent speed
selected.
