User manual page 2
F I R S T U S E
Install the cartridge:
Lay entiffic 2.4 on a flat even surface. Remove “D - cartridge cover” by unsnapping “E -
lower press snap button” on each side of the unit. Screw the gas cartridge (sold separately) on to “F - gas
cartridge receiving tread”. Make sure the cartridge is screwed on firmly. Refit the “D - cartridge cover” on
the unit and place it upright – the unit is ready for use.
Turn the unit on:
Press “1 - the on switch” to turn the gas “ON” – keep pressuring for 5-6 seconds while
simultaneously pressing “2 - Ignite button”, and you will instantly hear the gas being ignited. After approx.
20 seconds “1 – green indicator LED” will be illuminated, and shortly after this the fan will start to operate
and warm air will flow from “B – outlet vent”.
S H U T T I N G T H E U N I T O F F
entiffic 2.4 will continue to run until you either switch the unit off by shifting “1 – on/off switch” to “OFF”
or until the gas cartridge is empty.
Once shut off/gas is empty, the unit will continue to operate the fan and provide excess power to the “5 –
12V cigarette lighter socket” until the unit has cooled down.
R E M O V E / R E P L A C E T H E G A S C A R T R I D G E
Remove “D - cartridge cover” and unscrew the gas cartridge from “F - gas cartridge receiving tread”.
Replace the gas cartridge if needed. Make sure to dispose empty cartridges in a proper manor.
U S I N G T H E 3 – 1 2 V C I G A R E T T E L I G H T E R S O C K E T
entiffic 2.4 will provide up to 10W of excess power once it has reached operating temperature. You can
access this electrical power through “3 – 12V cigarette lighter socket” by means of a standard cigarette
lighter adapter. This outlet can charge your mobile phone/tablet, GPS device, MP3 player, camcorder,
rechargeable batteries, flash lights or provide electrical power to a light
(note: Not all manufacturers products may be
supported).
The max output of the socket is approx. 10W. Should the unit be connected to an electrical power
consumer that exceeds 10W, the “X – red warning LED” will be illuminated and the unit will refrain from
providing electrical power at all. To reset the power supply, disconnect the device, and reconnect another
device, consuming max 10W.
H A N D L E / B E L T
The woven belt “A” on top of entiffic 2.4 can be used for either carrying or hanging the device. You cannot
remove the belt from the unit. The belt can without risk, rest on the top of the unit, even during use of the
unit.
