Enterasys SecureStack C2 C2RPS-POE, Руководство по установке, Страница: 23 / 34

Installing the C2RPS-POE on a Flat Surface
SecureStack C2 Installation Guide 2-3
Installing the Rubber Feet
To install the rubber feet, refer to Figure 2 ‐ 1 and proceed as follows:
1. Place the C2RPS ‐ POE on its back on a sturdy flat surface to gain access to the bottom
of the chassis.
2. Remove the four rubber feet from their plastic bag in the shipping box.
3. Locate the four marked locations on the bottom four corners of the C2RPS ‐ POE.
Figure 2-1 C2RPS-POE Bottom, Rubber Feet Placement
4. Remove the protective strip from the back of one rubber foot and position it on a
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet.
5. After installing the rubber feet, return the C2RPS ‐ POE to its upright position.
6. To install the C2RPS ‐ POE on a flat surface, proceed to “ Installing the C2RPS ‐ POE on a
Flat Surface ” on page 2 ‐ 2. For a rackmount installation, proceed to “ Rack Mounting
the C2RPS ‐ POE ” on page 2 ‐ 5.
1 Bottom of C2RPS-POE 3 Rubber feet with adhesive backing (4)
2 Locations to install the rubber feet (4 locations)
À Á
 Â
 Â