Enterasys SecureStack C2 C2G124-48P, Руководство по установке оборудования, Страница: 42 / 82

Connecting High-Speed Stacking Cables
3-10 Hardware Installation
Figure 3-5 Attaching the Rackmount Brackets
2. With the mounting brackets attached, position the switch between the vertical frame
members of the 19 ‐ inch rack as shown in Figure 3 ‐ 6 . Then fasten the switch securely
to the frame using four mounting screws (user supplied).
Figure 3-6 Fastening the Switch to the Rack
3. If you are installing this switch in a stacked configuration, repeat this procedure for
each switch until all switches have been installed in the stack, then proceed to
“ Connecting High ‐ Speed Stacking Cables ” on page 3 ‐ 10. Otherwise, proceed to
“ Connecting AC and PoE Power ” on page 3 ‐ 15.
Connecting High-Speed Stacking Cables
The stack of switches can be connected in a ring or daisy chain topology. In a ring
topology all the switches are connected. The only difference in the cable connections in a
daisy chain topology is that one cable is not installed.
Up to 8 switches can be stacked together using C2CAB ‐ SHORT and C2CAB ‐ LONG
high ‐ speed stacking cables. You can add switches and reach up to a maximum of 384
Ethernet ports per stack. The high ‐ speed stacking cables allow the entire stack to operate
with a single IP address.
1 Rackmount brackets 2 M3 x 6 mm flathead screws
1 Rails of 19-inch rack 2 Mounting screws (supplied by user)
Console
1
2
45
CPU
UP
RPS
MGR
DOWN
46
47
48
47
48
C2G124-48P 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
15
16
17
18
31
32
33
34
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 45 46 47 48
Á À Á À
Console
1
2
45
CPU
UP
RPS
MGR
DOWN
46
47
48
47
48
C2G124-48P 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
15
16
17
18
31
32
33
34
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 45 46 47 48
À
Á
Á
À