Enterasys Matrix-V V2H124-24P, Руководство по настройке

Страница: 397 / 498

Rate Limit Commands
4-163
4
Example
The following shows mirroring configured from port 6 to port 11:
Rate Limit Commands
This function allows the network manager to control the maximum rate for traffic
transmitted or received on an interface. Rate limiting is configured on interfaces at
the edge of a network to limit traffic into or out of the network. Traffic that falls within
the rate limit is transmitted, while packets that exceed the acceptable amount of
traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface is
configured with this feature, the traffic rate will be monitored by the hardware to
verify conformity. Non-conforming traffic is dropped, conforming traffic is forwarded
without any changes.
rate-limit
Use this command to define the rate limit for a specific interface. Use this command
without specifying a rate to restore the default rate. Use the
no form to restore the
default status of disabled.
Syntax
rate-limit { input | output } [ rate ]
no rate-limit { input | output }
• input – Input rate
• output – Output rate
- rate – Maximum value in Mbps.
Default Setting
Fast Ethernet interface – 100 Mbps
Gigabit Ethernet interface – 1000 Mbps
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6
Console(config-if)#end
Console#show port monitor
Port Mirroring
-------------------------------------
Destination port(listen port):Eth1/1
Source port(monitored port) :Eth1/6
Mode :RX/TX
Console#
Table 4-51. Rate Limit Commands
Command Function Mode Page
rate-limit Configures the maximum input or output rate for a port IC 4-163