Enterasys Matrix-V V2H124-24P, Руководство по настройке

Страница: 155 / 498

Port Configuration
3-105
3
Command Attribute
• Rate Limit – Sets the output rate limit for an interface.
Default Status – Disabled
Default Rate – 100 Mbps
Range – 1 - 1000 Mbps
Web - Click Rate Limit, Input/Output Port/Trunk Configuration. Set the Input Rate
Limit Status or Output Rate Limit Status, then set the rate limit for the individual
interfaces, and click Apply.
Figure 3-64. Configuring Output Port Rate Limiting
CLI - This example sets the rate limit for input and output traffic passing through
port 1 to 600 Mbps.
Showing Port Statistics
You can display standard statistics on network traffic from the Interfaces Group and
Ethernet-like MIBs, as well as a detailed breakdown of traffic based on the RMON
MIB. Interfaces and Ethernet-like statistics display errors on the traffic passing
through each port. This information can be used to identify potential problems with
the switch (such as a faulty port or unusually heavy loading). RMON statistics
provide access to a broad range of statistics, including a total count of different
frame types and sizes passing through each port. All values displayed have been
accumulated since the last system reboot, and are shown as counts per second.
Statistics are refreshed every 60 seconds by default.
Note: RMON groups 2, 3 and 9 can only be accessed using SNMP management
software such as HP OpenView.
Console(config)#interface ethernet 1/1 4-151
Console(config-if)#rate-limit input 600 4-163
Console(config-if)#rate-limit output 600 4-163
Console(config-if)#