Enterasys Matrix N7 7C107, Руководство по установке

Страница: 30 / 48

Unpacking the Matrix N7 Chassis
3-2 Matrix N7 Chassis Setup
4. Remove and save the four screws fastening the rear shipping bracket/shelf to the skid. Remove
the rear shipping bracket/shelf from the skid and set aside for later installation in the rack.
5. Open the top of the shipping bag covering the unit, then pull the bag down around the skid.
6. Remove and save the accessory package, any other documents, and cable from the top of the
styrofoam cap. The accessory package contains the following:
•
Electrostatic Discharge (ESD) wrist strap
•
Installation Documentation
•
Rubber feet and screw assemblies
•
Cable management bar and associated hardware
7. Lift and remove the styrofoam cap from the top of the chassis. Save for reshipping if necessary.
8. Remove and save the eight screws fastening left and right shipping brackets to the chassis and
the skid. Remove and save the brackets, and also the foam sheets, which are between the chassis
and the brackets.
9. Lift and remove the chassis from the skid.
10. Save the plastic bag and skid for future reshipment if necessary.
NOTE: The rear shipping bracket is also the shelf used to mount the chassis in an
equipment rack. Instructions for installing the shelf into the rack are provided in
Section 3.2.3.1 .
NOTE: To reship the chassis, refer to Figure 3-1 and perform each step in reverse and
in the reverse order. Ensure that all shipping brackets are used including the one that
also serves as the shelf (rear shipping bracket).