TM
BrightEye 90-FA
Manual
• Width
– sets the aspect ratio width (range is
30
to
145
, default is
100
).
•
Height
– sets the aspect ratio height (range is
30
to
140
, default is
100
).
•
Hor Position
– sets the horizontal position of the output (range is
-100
to
100
, default is
0
).
•
Ver Position
– sets the vertical position of the output (range is
-100
to
100
,
default is
0
).
Use the
Default
button in each control to return to the default value.
Config
•
Noise Reduce
– adjusts the amount of noise reduction on the output signal
from
Low
,
Medium
, or
High
. The typical setting for this parameter is
Off
or
Low
.
•
Detail
– adjusts the amount of picture detail enhancement on the output from
Low
,
Medium
, or
High
. The typical setting for this parameter is
Off
or
Low
.
•
3:2 Detect
– turns the control to detect video that has been converted from
film, on or off. Use this only for film applications. The typical setting for this
parameter is
Off
.
•
Cpst Setup
– turns on Setup on the composite output
On
or
Off
(525 only).
Set this to
On
if your material has Setup on it.
•
Vert Blanking
– sets the blanking mode to
Narrow
(lines 1-9 are blanked
in NTSC, lines 1-6 in PAL) or
Wide
(lines 1-20 in NTSC, lines 1-22 in PAL).
•
Output Muting
– set to either
Mute On Noise
or
Off
.
Mute On Noise
means that the module will mute the video output (output a black signal)
when the module detects that the video quality is unacceptable.
Off
allows
the video to pass through to the output regardless of video quality.
BrightEye-15
