Visit
www.ensalife.com
for support
13
4.4 Disable Motion Activated LED Light
4.5 Check Solar Pabel On/Off Duration
4.6 Test LED Light
4.7 Lock/Unlock the Remote Control
To disable the LED light system again, simply change the
Drive Mode
from
Move Sensor
to
Time Ctrl.
This will skip every Interval after the sun sets, so editing other values after this point is unnecessary.
To check the solar panel’s current settings configuration, scroll to the SysConfig menu and press
Enter
. This will show info such as photovoltaic voltage, battery voltage, output voltage, current and
power, temperature and total operating time in minutes and more.
1.
Point the remote control at the solar panel’s black sensor and press Test.
2. Test the LED light by adjusting the light level on the remote screen with the Test button. This
scrolls through different light percentages. (100%, 70%, 50%, 30% and 0%)
After setup has been completed, you can lock the remote control to prevent changing the parameters
accidentally.
To lock/Unlock the remote control,
press the
Test,
Enter and
Back
buttons together.
If you hear a single beep, the remote is locked. If you hear three beeps, the remote is unlocked.
