Enraf Tanksystem HERMetic UTImeter Rtex, Руководство по эксплуатации и обслуживанию

Страница: 36 / 77

50455/RTEX/0807 UTImeter Rtex
36
9.2 Checking the battery
Please note that in case you have to change the battery, it must be done only in a safe area.
Refer to section 9.3 "Battery replacement".
9.2.1 Before starting gauging
Switch on the unit. The buzzer tones every 2 seconds if the battery is not too low.
The following sequences are displayed as per Figure 9-1, the 4
th
sequence shows the remaining power of the
battery in percentage and as a bar-graph.
If the power left is less than 50% we recommend to have a spare battery ready for exchange. See also 9.3
"Battery replacement".
If the power left is less than 20% the message is blinking to advise that the power may not be enough to carry
out all the work.
ON
UTImeter
Battery
Init.
*********
25.94°C
Ver x.xx
ééééé
97%
Figure 9-1
If the battery is too low, the unit will stop on the message "battery" as shown on Figure 9-2 and the buzzer
tones continuously. Change the battery as per 9.3 "Battery replacement".
ON
UTImet er
Bat tery
Init .
*********
Bat tery
Ver x.xx
░
0%
Figure 9-2
If it is not possible to switch on the unit, the battery is out or work. Change the battery first, as per
9.3 "
Battery
replacement
".