Enplus Evo UPS 1000VA, Руководство пользователя

Страница: 25 / 44

25
USB port (option)
Connecting the UPS to your computer is accomplished through the USB port on the back of your
computer. USB compliant hardware and operating system will be necessary including installation of
a UPS driver. The serial port cannot be used when using the USB port. The USB cable is standard
and can be bought separately.
6.1 EPO port (emergency power off)
A customer-supplied switch located remotely can be used to open the EPO connection and allows
UPS output receptacles to be switched off. Since the EPO shuts down the equipment immediately,
orderly shutdown procedures are not followed and not by any power management software. The
UPS will have to be manually restarted in order to regain power to the outlets.
Network Transient protector (1000 - 3000 VA)
The network transient protector, located on the back panel, has both IN and OUT jacks, and houses a
single RJ-45 (10BaseT) network connector. Connect the input connector to the jack labeled IN, and
the output connector to the jack labeled OUT.
6.2 Load segments (1000 - 3000 VA)
The power management software controls the sets of receptacles known as load segments which
provides organized shutdown and startup of the equipment. Less critical equipment can be turned off
during power outages saving battery power for critical loads. The power management software
manual has more details regarding this. The load group status can be viewed from the LCD display
and can be changed if necessary. These load segments are usually handled with the UPS
management software. Refer to chapter 5.2 regarding the two load segments that come with each
model.