enphase ET10-208-30, Руководство по установке

Страница: 17 / 28

Page 17 Copyright Enphase Energy Inc. 2011 141-00013 Rev 03b
Step 6 – Terminate the Unused End of the Engage Cable
Attaching the Terminator
The terminator is intended for one-time use only. If you open
the terminator following installation, the latching mechanism
is destroyed and the terminator cap cannot be used again. If
the latching mechanism is defective, the terminator must not be used. The
latching mechanism must not be circumvented or manipulated.
Adhere to the following requirements:
Use of the terminator assembly is the only method allowed to seal the
conductor end of the trunk.
Do not expose the terminator cap to directed, pressurized liquid (water
jets, etc.).
Do not expose the terminator cap to continuous immersion.
Do not expose the terminator cap to continuous tension (e.g., tension
due to pulling or bending the cable near the terminator cap)
Do not install or use in potentially explosive environments.
Do not allow the terminator to come into contact with open flame.
Use the terminator cap assembly only when all parts are present and
intact.
Fit the terminator cap using only the prescribed tools.
To attach the terminator:
a. Check the terminator cap assembly for completeness. It is made up of the
individual parts shown.
b. To guarantee the safety of the wire
organizer and to ensure that it remains
sealed, please make sure that all parts are
present and that all seals are seated
correctly in the wire organizer.
The wire organizer must be complete, as shown.
Risk of Electrical Shock. The terminator cap must not be
installed while power is connected.
Cable seal
O-ring
Hex nut Wire organizer Cap