enphase Envoy Communications Gateway, Инструкция по установке и эксплуатации

Страница: 26 / 100

Copyright 2011 Enphase Energy 141-00014 Rev 01
e
n
g
l
i
s
h
22
Viewing the Grid Configuration
To view the grid configuration (trip points profile) for the site, do the following.
Note : You cannot change the grid profile using this menu. To change this
profile, you must follow the instructions on page 12.
1. Press and hold the Envoy Menu button; after two seconds you will enter the
Envoy menu.
2. Continue holding the Menu button; when the LCD screen displays “View Grid
Configuration”, release the Menu button.
The LCD screen then reads:
If a grid profile has not been applied, the following screen is displayed:
This indicates that the microinverters are not yet configured with a grid
profile and cannot produce power until they are set. Configure these settings
as described on page 12. You can press the menu button exit this process.
If a grid profile has been applied, the following screens are displayed. You
can press the menu button at any time to exit this process.
Number of microinverters detected.
Number of microinverters that are
set with a grid profile and the name
of the local grid profile being used.
Number of microinverters that are
in the process of being set and the
name of the grid profile being used.
(n)are propagating
with (local spec)
(n)devices are set
with (local spec)
(n) total devices
Gathering Grid
Configuration Data
View Grid
Configuration
No Grid
Config. Applied