III-5-5 IrDA Compliant Infrared Module Connector
These connectors support the optional wireless transmitting and receiving
infrared module. This module mounts to a small opening on system cases
that support this feature. You must also configure UART 2. Use Infrared in
Chipset Features Setup to select whether UART 2 is directed for use with
COM2 or IrDA. When IrDA is selected in BIOS, COM2 will be disabled. Use
the five pins or six pins as shown and connect a ribbon cable from the
module to the motherboard to the pin definitions. There are two connectors
are available for the IrDA, one is near to Front Panel the other is rear, user
can use one of them to connect to IrDA module depending on the location
you want.
1
5
1. Vcc
2. NC
3. IR_RX
4. GND
5. IR_TX
III-5-6
Wake-On-LAN (WOL)
Attach the 3-pin connector from the LAN card which supports the Wake-
On-LAN (WOL) function to the WOL connector on the motherboard. This
WOL function lets users wake up the connected computer through the LAN
card. Please install according to the following pin assignment:
Sensor
5VSB
GND
WOL
IR1
IR2
1 2 3