USER MANUAL
TCM 410J
–
Transceiver Module
© 2022 EnOcean | www.enocean.com
TCM 410J User Manual | v2.3 | June 2022 | Page 14 / 46
2.7
Serial Interface
TCM 410J provides a bi-directional serial interface according to the EnOcean ESP3 specifica-
tion. For details regarding ESP3 please refer to the ESP3 specification. The data rate on the
serial interface is 56.8 kbit/s which is usually interoperable with systems running at
57.6 kbit/s.
Direction
Nominal serial data rate
Tolerance
TX (sent by module)
56888 bit/s (=57600 bit/s - 1.23%)
< 50 ppm
RX (received by module) 56888 bit/s
< 5%
The following ESP3 commands are supported:
◼
Type 10 : Radio Packet
◼
Type 2: Responses
◼
Type 4: Event
o
SA_CONFIRM_LEARN to confirm/discard learn in/out
o
CO_READY to indicate wake up from deep sleep initiated by CO_WR_SLEEP
◼
Type 4: Event related to security processing
CO_EVENT_SECUREDEVICES
◼
Type 5: Common commands
o
CO_WR_SLEEP to enter energy saving mode (deep sleep mode)
o
CO_WR_RESET to reset the device
o
CO_RD_VERSION to read SW/HW versions, chip ID etc.
o
CO_WR_IDBASE to write ID range base number
o
CO_RD_IDBASE to read ID range base number
o
CO_WR_REPEATER to configure repeater functionality
o
CO_RD_REPEATER to read repeater state
o
CO_WR_FILTER_ADD to add filter to filter list (up to 10 filters are supported)
o
CO_WR_FILTER_DEL to delete filter from filter list
o
CO_WR_FILTER_DEL_ALL to delete all filter
o
CO_WR_FILTER_ENABLE to enable/disable supplied filters
o
CO_RD_FILTER to read supplied filters
o
CO_WR_WAIT_MATURITY to wait maturity time before returning radio telegrams
◼
Type 5: Common commands related to security processing
o
CO_WR_LEARNMODE
o
CO_RD_LEARNMODE
o
CO_WR_SECUREDEVICE_ADD
o
CO_WR_SECUREDEVICE_DEL
o
CO_RD_SECUREDEVICE_COUNT
o
CO_RD_SECUREDEVICE_BY_INDEX
o
CO_RD_SECUREDEVICE_BY_ID
o
CO_WR_SECUREDEVICE_SENDTEACHIN
o
CO_WR_SECUREDEVICE_ADD_PSK
o
CO_WR_TEMPORARY_RLC_WINDOW
