CHAPTER 7. USB CONSOLE
page 27
Figure 7.7: Firmware update site.
To update your target’s firmware follow the steps below:
1. Choose the firmware file your device should be updated to by clicking the "Browse" button and selecting the
according file.
2. Upload the file via the "Start Upload" button.
3. Once the upload finishes, the firmware version, hardware revision and device configuration of the chosen
upload file will be displayed. Also, the button "Update firmware" appears. Click this button to start update
your devices firmware. Notice the blinking LEDs of the device.
4. Once the LEDs stop blinking, your firmware update is finished.
Before updating your capt
2
web device always run it with the included power supply
adaptor and do not use power over USB. It is very important not to disconnect the
target from the power supply during the update process since this will cause a broken
firmware and can’t be fixed by yourself. In case your device doesn’t restart properly
after an update, please contact STZEDN.
Steinbeis Transfer Center Embedded Design and Networking
Baden-Württemberg Cooperative State University Lörrach
Prof. Dr.-Ing. Axel Sikora
Содержание capt2web
Страница 1: ...EnOcean User manual November 16 2009 ...