LC-Series Controller: 1-4 Channel
ENMET
Manual Revision Date – June 13, 2017
P a g e
|
2
Manual Part No. – 80003-050
1.0 Introduction
The LC Series Control Units that provide facilities to monitor a wide variety of industry standard environmental and other sensors.
The LC1 provides 1 monitoring channel.
The LC2 provides up to 2 monitoring channels.
The LC4 provides up to 4 monitoring channels.
The
LC-Series Controller
has been designed to allow the use of any ENMET sensor transmitter and has been preprogrammed to
match the sensor transmitters supplied at time of delivery. The
LC-Series
can also be used with any manufactures sensor transmitter
that can produce a voltage or current output within a specified range; however, it is advisable that you contact ENMET for proper
setup and programming instructions. Care has been taken with the design of the MCU housings and internal chassis to facilitate ease
of connection and wire termination. All on-site wiring to the system is via screw terminal connectors. The terminal cover has an
internal label giving details of the external connections.
N
OTE
:
All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the
LC-Series Controller
and examine it for shipping damage. If such damage is observed, notify both
ENMET
customer service personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N
OTE
: It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor any claims for
damage.
This shipment was carefully inspected, verified and properly packaged at
ENMET
and delivered to the carrier in good
condition.
When it was picked up by the carrier at
ENMET
, it legally became your company’s property.
If your shipment arrives damaged:
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET
Customer Service for return authorization and further instructions. Please have your Purchase Order and Sales
Order numbers available.
ENMET
either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage, usually
$100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage.
ENMET
only insures shipments with the shipping company
when asked to do so in writing by our customer. If you need your shipments insured, please forward a written request to
ENMET
Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify
ENMET
Customer Service within 5 days of receipt at
the following address:
ENMET
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 Fax 734-761-3220
Toll Free: 800-521-2978
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the
LC-Series Controller
is received as ordered. If
there are accessories on the order, ascertain that they are present. Check the contents of calibration kits. Notify
ENMET
customer
service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each
LC-Series Controller
is serialized. These numbers are on tags on the equipment and are on record in an
ENMET
database.
