ENKHO 154700.01, Оригинальное руководство пользователя, Страница: 30 / 66

EN
30
Press on the battery charge level button (18)
on the battery pack (8). You can read the
battery status from the battery level indication
(LED) (14).
Tool Change (Fig.E & F & G)
The device is equipped with a fully automatic
spindle lock. When the tool is at a standstill, the
motor drive train is locked so that the keyless
drill chuck can be opened. Please proceed as
follows to remove or insert tools:
1. Set the switch for clockwise/counter-
clockwise rotation (4) to center position
(lock).
2. Turn the keyless drill chuck (1) counter-
clockwise to open it (fig. E)
3. If necessary, take the drill bit out of the drill
chuck.
4. Insert the appropriate (drill) bit into the drill
chuck (1).
5. Tighten the keyless drill chuck (1) by
turning clockwise.
Torque selection /drilling setting (Fig. H & I)
Using the torque selection (2), you can choose
the desired, optimal torque setting.
- Select a low torque for smooth-running
screws or soft materials.
- Select a high torque for tight screws and
hard materials as well as unscrewing.
- For drilling, select the drilling setting
indicated by the symbol .
Note: Do not use the drilling setting for
screwing
Two-speed level (Fig. J)
Note: Only use the gear selection when the
device is at a standstill! Otherwise the device
might be damaged.
1. Slide the gear selection (3) to the desired
position.
2. Speed level 1: speed of up to 400/min,
suitable for all screwing applications.
3. Speed level 2: speed of up to 1550/min,
suitable for drilling.
Mounting the belt clip (Fig. K)
Optionally you can mount the belt clip included
in the scope of delivery to the device.
1. Set the switch for clockwise/counter-
clockwise rotation (4) to center position
(lock).
2. Loosen the screw at the attachment (7) for
the belt clip.
3. Fasten the belt clip (12) to the belt clip
attachment (7) by means of the screw.
5. Operation
Tips and notes on handling the cordless drill
General information
∫ Check the tool in the keyless drill chuck for
correct fit before every application. It must
be firmly locked and centered in the drill
chuck.
∫ Screw bits are marked with their size and
shape. If you are unsure, check whether the
bit can be firmly tightened in the keyless
drill chuck without clearance.
∫ The center position of the switch for
clockwise/counter-clockwise rotation
(lock) is suited for work breaks or (drill) bit
exchange.
Screwing
∫ In case of soft wood, screws can be
screwed in without pre-drilling.
∫ In case of hard wood or large screws, it is
recommended to use a drill for pre-drilling.
∫ When using countersunk screws, the drill
hole should be countersunk beforehand.
∫ Especially smaller screws and bits may
be damaged when selecting an excessive
torque and /or speed at the tool.
Drilling in General
∫ Take short breaks regularly during drilling,
when doing so, take the drill bit out of the
drill hole so that the drill bit can cool down.
∫ Secure the workpiece in a tensioning device
or vice.
∫ Select the speed depending on the material
characteristics and the size of the drill bit:
- High speed for small drilling diameter or
soft material