ENGWE-BIKES SJB-1, Руководство по эксплуатации и обслуживанию

Страница: 9 / 20



Assembly - Step 3: Attach the Front Wheel and Adjusting the Front Brake
Make sure that the fork from the steering column is pointing forward. Remove the
protective bar from the front fork, place the front wheel within the fork and the brake
disc within the brake block, seat the axial stem properly within the receptacles at
the tips of the fork, and tighten the nuts with the multi-wrench. Make sure that the
front wheel moves freely and does not wobble from side to side. Reposition the
wheel and re-tighten if necessary.
Test the brake by lifting the front of the e-bike and setting the wheel in motion
(turn it) and apply the brake at the handlebar to stop it. If you could not set the
wheel in free motion, or if you could not stop it by applying the brake, you need to
re-adjust by increasing or decreasing the clearance.
Caution: Do not operate the e-bike until you are satisfied that both the front and
rear brakes are operational.

Assembly - Step 4: Installing the Seat and Pedals
Insert the pedestal stem of the seat into the seat column of the main body frame,
use the built-in lever to tighten.
Attach a pedal on each side of the crank, tighten with the multi-wrench.
Inflate the tires to proper pressure.
At this point, your e-bike is a completely functional bicycle, although without any
battery operated to function as yet. Check all tightening points to make sure. Take a
short ride. Adjust the height of the handlebar, and the height and the tilt of the seat,
if necessary, for maximum comfort.
- 8 -