ENGLEFIELD
DURACYL WALL
INSTALLATION INSTRUCTIONS
Page 5
Adhesive line
DURACRYL WALL INSTALLATION
Tiling bead (upstand)
Bath wall liner
Fig.4: Cutting base protector
Fig.5: Mark and drill holes for plumbing
Fig.6: Positioning wall
Fig.7: Bath tub notching
Fig.8: Marking liner edge onto wall board
Ensure the shower tray or bath tub is installed
correctly, as detailed in the installation guide
supplied with the product. Peel back protective
fi
lm of the tiling bead of shower tray or bath
in order to make a water tight seal possible.
Ensure the surface of tray or bath tub is
protected during installation, and no debris
can get into the waste hole. For bath tubs use
a drop cloth.
For shower trays, select appropriate size, then
cut base protector from back of shower tray
carton. Place it in shower tray as per
Mark and drill holes required for outlet fittings
as per
.
NOTE:
Follow the drilling and cutting
instructions from page 3.
Position wall in place. Check
fi
t to ensure wall
fi
ts squarely into corner as per
Tape
edges to hold into position.
Where necessary (bath) notch the edge of wall
.
Before marking, make sure the wall is pressed
firmly into the corner of wall.
With a soft pencil, mark around the perimeter of
the wall liner. This will be the basis for marking the
glue pattern as per
1. PREPARING WALL AND SPACE
to fit over the tiling bead as shown in
