ENGLEFIELD
DURACYL WALL
INSTALLATION INSTRUCTIONS
Page 3
SEALANT & ADHESIVE
Small holes can be drilled with a twist drill, but the cutting edge MUST be backed off with an oil
stone (the sharp edge dulled). Large holes must be drilled with a hole saw.
Maximum drill size : 12 mm. Drill speeds: 6 mm x 1800 RPM ; 12 mm x 900 RPM.
If for any reason the Duracryl requires cutting, use a fine tooth hacksaw and proceed with caution.
Edges can be smoothed with a second-cut file and medium-fine sandpaper
. If the surface of the
Duracryl happens to be damaged, it can be restored by polishing with an appropriate compound.
DRILLING AND CUTTING DURACRYL
16520A-0
16521A-SHP
16522A-0
16523A-SHP
Adhesive & sealant pack -
3 sided
wall
liner for
metallic/black
framed showers.
Adhesive & sealant pack -
3 sided
wall
liner for
white
framed showers.
The recommended adhesive and sealants are:
to adhere the
acrylic liner to the wallboard.
to seal the
acrylic liner to shower tray or bath.
• Sika Shower Bond
• Sika Sikasil NG (White)
Usage: • 3 cartridges for 2 sided wall liners
• 4 cartridges for 3 sided wall liners
These are available in separate Adhesive &
Sealants Packs. Each Pack contains enough
adhesive and sealant for a complete shower
enclosure or shower over bath installation.
For stockists phone 0800 100 382 (NZ) or
1800 ENGLEFIELD (Australia).
Adhesive & sealant pack -
2 sided
wall
liner for
metallic/black
framed showers.
Adhesive & sealant pack -
2 sided
wall
liner for
white
framed showers.
