IMPORTANT!
READ AND FOLLOW
ALL
INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
37
Air
Controls:
Your
pellet
stove
is
equipped
with
a
control
board
that
automatically
adjusts
the
air
to
fuel
ratio
for
optimum
emissions.
See
your
owner’s
manual
for
information
on
operating
the
control
board,
and
for
other
operational
information
on
achieving
the
best
burn,
including
these
tips:
The
control
board
on
this
stove
allows
the
user
to
adjust
the
heat
output
and
convection
blower
speed,
and
turn
the
unit
on
and
off.
The
lower
buttons
on
the
control
board
(Low
Fuel
Feed,
Low
Burn
Air,
and
Air
on
Temp)
are
not
meant
to
be
adjusted
during
normal
operation
of
the
unit.
These
buttons
are
factory
preset
and
should
not
be
adjusted
by
the
user.
To
energize
the
unit
and
initiate
a
fire,
press
the
“On”
button.
The
LED
above
the
button
should
turn
green
and
the
control
board
should
display
“S
U”
shortly
after
pressing
the
button.
To
shut
the
unit
down,
press
the
“Off”
button.
The
LED
above
the
button
should
turn
red
and
the
board
should
display
“S
d”
shortly
after
pressing
the
button.
This
initiates
the
shut
down
sequence,
and
the
stove
will
remain
in
shut
down
mode
until
it
has
cooled
down.
To
increase
the
heat
output
of
the
stove,
press
the
“Up”
heat
range
button.
The
number
in
the
heat
range
display
window
will
increase,
signifying
that
the
control
board
is
now
adjusting
the
heat
output
to
your
desired
level.
The
blower
speed
will
increase
the
same
amount
as
the
heat
range,
because
the
stove
is
designed
to
operate
with
the
blower
speed
greater
than
or
equal
to
the
heat
range.
Pressing
the
“Down”
arrow
will
decrease
the
heat
range
and
blower
speed.
To
increase
the
blower
speed
without
increasing
the
heat
range,
press
the
Blower
Speed
“Up”
arrow
until
the
desired
blower
speed
is
shown
in
the
display
window.
Pressing
the
“Down”
arrow
will
decrease
the
blower
speed;
however,
the
control
board
will
not
allow
the
blower
speed
to
be
set
lower
than
the
heat
range
.
Caution
This
unit
is
meant
to
operate
only
with
the
ash
pan
and
main
viewing
door
closed.
Smoke
spillage
and
an
inefficient,
lazy
burn
will
result
from
attempting
to
operate
the
stove
with
either
door
open.
In
addition,
using
fuel
other
than
wood
pellets
can
create
an
unsafe
situation
and
can
also
generate
excess
carbon
monoxide.
Carbon
monoxide
is
an
odorless,
colorless
gas
which
can
be
deadly.
Be
sure
to
burn
only
wood
pellets.
The
use
of
a
carbon
monoxide
detector
is
strongly
recommended.
Содержание 25-PDVC
Страница 39: ......
