IMPORTANT!
READ AND FOLLOW
ALL
INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLANDER IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO
UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
ACCESSORY ITEMS
The following accessories can be added to your unit at anytime after purchase; however, let the
unit cool down before adding any accessories.
Thermostat
An external wall thermostat can be used on our pellet units, as long as it is a low-voltage type
that works with millivolt systems. After unplugging the unit, locate the jumper wire (J-18) on the
bottom of the control panel. The two screws should then be loosened and the jumper wire removed
from the board. Next, the two thermostat lead wires should be slipped into these openings and the
screws tightened; the jumper wire should be saved for future operation without a thermostat.
The unit will operate differently once the wall thermostat is connected – we recommend the
Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to
the section on “Start-up Procedure” for information on cold starts. Please Note, the unit will not turn
On and Off when using the thermostat. It will go into an Idle Mode when it reaches the set
temperature.
AC-106-PBN Window Trim
Window trim can be attached by using the provided spring clip(s) and some high temperature
silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then,
turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it is
placed on the top edge of the trim before placing the trim in the window of the stove. Place the top
edge with the clip into the window opening, then push the bottom edge of the trim flush with the
window. We also suggest that high temperature silicone be used on the corners, to ensure the trim
will stay in place.
AC-CT Cleaning Tool
The cleaning tool is a great, handy tool for cleaning pellet stoves of any make or model. The tip
end is designed for cleaning holes in the burn pot, and the flat end is designed to scrape off stubborn
ash deposits. There is also a 5/16” cutout on the tip end that fits over the 5/16” screws on our pellet
models, for when you don’t have a wrench or socket nearby.
Accessories can be ordered on our web site:
For Questions/Problems
: Please call Technical Support at (877) 356-6663.
You may also order parts and options, view frequently asked questions and more,
on our web site:
