from the amp or MIDI device:
-> Is the MIDI cord defective (say, a short circuit or broken wire)?
Does it have the correct pin assignments?
-> Check cable connections: Is the foot controller's
connected
to the
on the ENGL amp or MIDI device?
-> Are the Z-15 foot controller and the amp (or effect device) set to the same
MIDI channel? To check this, you can set the amp (or effect device) to OMNI
receive mode. In this mode, MIDI data received via all 16 channels are accepted.
Check the foot controller's MIDI send channel setting in the
routine and, if necessary, set it to the correct channel. Like program change
commands, controller commands are sent with a channel number.
-> Is the controller number setting on the foot controller consistent with the
controller number of the function that you want to remote control at the amp
or effect device? Example: On the E580 Preamp, controller number 7 has a
fixed assignment to master volume. If you use a
on the ENGL Z-15 to address this function, you must assign controller number 7
to it in the appropriate
routine.
-> Is the given controller function enabled at the amp or effect device?
Consult the amp or effect device's manual to learn how to enable or activate
the controller.
-> Go to the
and adjust the send interval
accordingly (that is, decrease or increase it).
-> Change the curve characteristic in the appropriate
.
-> Check terminal assignments. The assignments for the two jacks that access the
four
are on page 23.
-> Check if the cord connecting the amp and the foot controller has a short-circuit
or broken wire.
-> Did you plug the stereo cord's connector into one of the two jacks labeled
& and
& ?
-> Check if the foot controller is switching the two
that are connected
to the amp via the stereo cord.
-> Is the stereo cord properly plugged into the amp?
-> The display reads >Ulo<, indicating that the voltage is too low.
-> The display reads >Uhi<<, indicating that the voltage is too high.
-> Make sure the operating voltage corresponds to the stipulated specifications.
MIDI Out
MIDI In
MIDI Channel Setup
continuous controller
Controller Setup
Controller Setup
Controller Setup
Switch Loops
Switch Loop 1 2
Switch Loop 3 4
Switch Loops
The amp or effect device's response to the expression pedal or
action is uneven, abrupt, choppy or too slow.
The amp or effect device's response is the opposite of the expression pedal or
action.
The functions of an amp addressed by the Z-15's
do not respond
when activating or deactivating
.
The operating voltage supplied to the foot controller is too high or too low.
Internal
Continuous Controller's
Internal Continuous Controller's
Switch Loops
Switch Loops
20
All manuals and user guides at all-guides.com
