continuous controllers
Controller Setup
MIDI Program Direct
Access Mode
Controller Setup 1
Internal
Continuous Controller
Continuous Controller 1
MIDI Program Direct Access Mode
Controller Setup
Internal
Continuous Controller
Continuous Controller 2
Internal Continuous Controller
Internal
Continuous Controller
Internal Continuous Controller
MIDI Program Direct Access Mode
Controller Setup
external Continuous Controller 1
Internal Continuous Controller
MIDI Program Direct Access Mode
Controller Setup 2
9
9
4
1
2
MIDIProgramDirectAccessMode
0
9
9
MIDI Program Direct
AccessMode
Switch Loop 1
Switch Loop 2
Switch Loop 3
Switch Loop 4
MIDI Program Direct
Access Mode
Switch Loops
Up
4
MIDI Out
6
Switch Loop 2
Switch Loop 2
7
Switch Loop
Switch Loop 3
. The
routine from which
is accessed determines which parameter values are assigned to the
Internal Controller. If you access this mode from
, the
adopts the parameter settings of
. If
you activate
from
2, the
adopts the parameter settings of
.
The
is disabled when you plug an external
expression pedal into the port of the continuous controller that the
is currently emulating. This means that if you want to use the
along with an external continuous controller, ensure
that you do not activate
from the
routine for the external continuous controller assigned to the connected expression
pedal.
Confused? Don't be. Let's look at an example:
Say an expression pedal is connected to
. You
decide to use the
to emulate a second expression
pedal and employ it as an additional continuous controller.
To do this, change to
from
:
-> In the last bank 12x, press and hold until the display reads >Cn.2<.
-> Press again briefly; the MPN flashes in the display.
-> Confirm the MPN by pressing ; the MPN in the display stops flashing.
-> Set controller values using buttons and , whereby pressing and holding the
given button causes values to scroll continuously.
The display indicates controller values with a decimal point at the center and at
the right positions for the duration of the operation and a moment thereafter.
Then the current MPN appears in the display.
Callup
:Pressandholdthe buttoninthefirstbank
00x or the button in the last bank 12x for about three seconds until the display reads
>Cn.1< or >Cn.2<. Then press the button briefly to activate
.
Say you want to program the following configuration for MIDI patch 9:
- active;
- passive;
- passive,
-
active. The most recently selected patch before you changed to
was MPN 3. The currently stored status for all four MPN 9
is
active:
-> Press
six times or press and hold it until MPN 9 appears in the display.
The display reads >003<, >004<, >005<, >006<, >007<, >008<,
>009<; the display flashes.
-> Confirm MPN 9 by pressing ; the display reads >009<;
the flashing stops;
sends MPN 9.
-> Press to deactivate
; LED 2
for
extinguishes.
-> Press to deactivate
3; LED 3
for
extinguishes.
Note:
Configuring
to
Example:
SwitchLoops1 4
16
All manuals and user guides at all-guides.com
all-guides
.com