Page 46 of 71 Article no.: 1080621019 2021_12_10 Subject to technical change! Errors excepted.
2.2 Retrofitting S3C with an additional communication interface
To our calculator further communication interfaces can be added later.
Open the calculator by pulling the clamping bracket at the upper housing´s leading edge up.
Plug the interface module on the right side of the PC board. If there are module cables you have to loosen the
needed number of cable glands and to glide them over the cables. Remove the blind plugs from the cable gland
openings and feed the cables into the calculator.
Protect the calculator against unauthorized opening using one of the numbered adhesive seals enclosed to the
modules (stick it upon the seal destroyed). The added bar code label can be used for the purpose of
documentation.
3 Display in the Module Loop (Optional)
Level 6 / Module Loop:
1) Display of plugged
module (alternatively):
8 = wireless M-Bus + 3
pulse inputs;
9 = M-Bus + 3 pulse
inputs;
10 = 2 pulse outputs
or:
2) Display depending on
plugged module and
setup:
radio off;
radio on;
pulse value pulse output 1
or:
3) Display depending on
plugged module and
setup:
radio encryption (AES) off;
radio encryption (AES) on;
pulse value pulse output 2
4 Imprint
Engelmann Sensor GmbH
Rudolf-Diesel-Str. 24-28
69168 Wiesloch-Baiertal, Germany
E-Mail: [email protected]
www.engelmann.de
