ENFORCER Room Occupancy Monitor
4
SECO-LARM U.S.A., Inc.
Setting a Reminder Time:
Clear Channel Memory:
Display Channel Memory:
1.
Connect to power and press the pairing button within 5 seconds of powering on.
2.
After pressing the pairing button, count number of times the LEDs flash
3.
Press the pairing button until desired reminder time is set. See table below for reminder time
settings.
# of Flashes
1
2
3
4
5
6
7
Reminder time Disabled
3min
5min
10min
15min
20min
30min
The Room Monitor Sensors and Indicators can be programmed to flash if the room has been
occupied for an extended period of time.
Pairing
button
LED
Indicator
Sensor
(RM-R100-TLQ)
Service paring
button*
Ch1 Pairing
button
LED
Indicators
1-Room Indicator
(RM-R100-RB1Q)
Ch1 Pairing
button
LED
Indicators
Ch2 Pairing
button
2-Room Indicator
(RM-R100-R2Q)
To clear all codes from a channel’s memory, press the channel's pairing button for 3 seconds or
more until the channel indicator LED begins flashing. Release, and then press the button again for
3 seconds or more until the LED stops flashing. The LED will then flash twice to indicate that all
codes associated with that channel have been deleted.
To see how many codes have been learned by a channel, press that channel’s pairing button
once. The number of codes stored in the channel’s memory corresponds with the number of times
the channel's LED indicators flash.
*Service pairing button cannot be used to set a reminder time.
