ENFORCER 50ft Reflective Photoelectric Beam Sensor
SECO-LARM U.S.A., Inc.
3
1.
Mount the sensor and reflector so that they face
each other.
2.
Connect power to the sensor. The LED will light as
indicated in the chart below.
3.
Unscrew the 4 cover screws and remove the cover.
4.
To find the correct alignment, slowly turn the lens
assembly left and right to adjust the horizontal angle.
5.
Loosen the vertical adjustment screw to adjust the
vertical angle.
6.
Place the hood on the sensor by sliding the hood’s
ridges into the slots on the sides of the sensor.
7.
Re-attach the cover, replace the four screws, and
attach the hood to the top of the sensor.
1.
Unscrew the four cover screws and remove the cover.
2.
Loosen the captive screw and remove the sensor
from the mounting plate.
3.
Using the included mounting screws, mount the
mounting plate to the wall.
4.
Use the cable breakout and cable connector at
the bottom or rear of the sensor to run the wires.
5.
Hang the sensor back on the plate and use the captive screw to secure it in place.
6.
Re-attach the cover, replace the four screws, and attach the hood to the top of the sensor.
Mounting:
Alignment:
Solid green
Good beam signal,
properly aligned
Alternating flash
Poor beam signal
Solid red
No beam signal,
triggered
Lens
alignment
±90
±5
Horizontal
adjustment
Vertical
adjustment
Wiring for the Rear Cable Breakout
1.
Puncture the cable breakout located at the rear of
the sensor using a screwdriver or other object.
2.
Run wires through the included rubber ring.
3.
Install the weatherproofing ring with the wires already
installed in the cable breakout hole.
4.
Make sure the ring is secure and there is no room for
water to get into the unit.
Rubber
ring
Cable
breakout
Wiring for the Bottom Cable Breakout
1.
Puncture the cable breakout located at the bottom of
the sensor using a screwdriver or other object.
2.
Insert the short end side of the cable connector
into the cable breakout hole and use the nut to
secure it, tightening with a wrench as needed.
3.
Run the wires through the end cap and cable connector.
4.
Then screw the end cap into the external side of the cable
connector to prevent water from entering the unit.
Cable
Connector
End cap
Sensor
Nut
Rubber
neck
