VOICE DIALER Installation Manual
SECO-LARM U.S.A., Inc.
Page 8
1. Contact the company or person who
will be called by each of the recorded
telephone numbers prior to performing
an actual test in the OPERATE mode.
Advise the people at the numbers that
you are conducting a test, and ask
them to confirm with you that the
message was received and understood.
2. Turn the power "OFF".
3. Connect the dialer to the phone line
(see page 3).
4. The sensor should not be in the alarm
mode. If it is, the unit will start dialing
immediately.
5. Turn the power "ON"
TESTING THE UNIT — DIALING OUT THE PROGRAMMED
NUMBERS
Note: To ensure proper operation, the E-920A must be tested at least once in the
OPERATE mode, and the dialer must be connected to the phone lines.
Note: Prior to operation of the E-920A, be sure the power source is within the
specification and the wiring is connected properly. It is recommended that the
E-920A be tested under simulated alarm conditions and that the user receive
confirmation of transmission from the numbers dialed. Please note that the
SELF-TEST function allows for message and data confirmation without connecting
the E-920A to a telephone line.
To ensure the correct telephone numbers
and recorded messages have been
programmed properly, use the following
procedure.
1. Set the unit to the TEST mode by
pressing the "MODE" button.
2. The word "TEST" will appear on the
LCD, and telephone number stored in
memory location 1 will be displayed.
TESTING THE UNIT — NO OUTGOING MESSAGE (SELF-TEST)
3. Message 1 and/or message 2 will
play back through the speaker.
4. The process will automatically
repeat itself for memory location 2,
memory location 3, and memory
location 4.
5. Press the "MODE" button to return
the E-920A ttttto the PROGRAM or
OPERATE mode.
6. Use the "MODE" button to place the
unit in the OPERATE mode.
7. Trip trigger #1 or #2 to simulate an
alarm condition.
8. At this point the dialer should begin
to dial the telephone numbers stored
in memory locations 1 to 4. The
outgoing message (1 or 2,
depending on which trigger is
tripped) will be delivered twice once
the dialer receives an answer.
9. The message will repeat for the 2nd,
3rd, and 4th telephone numbers. If
a number is busy or unanswered
after 8 to 10 rings, that number will
be skipped, but it will be retried at a
later time.
