Enerzone Euromax EP00070, Инструкция по установке и эксплуатации

Страница: 22 / 100

22
Euromax Pellet Stove Installation and Operation Manual
4.5.5 Through an Existing Masonry Fireplace
1. Position stove, following clearances
shown in Section 3.2 Minimum
Clearances to Combustibles and
following vent manufacturer’s
instructions.
2. Build and Install a blocking plate inside
the chimney to seal the fireplace
damper. Stainless steel plate and
screws are recommended. Cut a hole
for the exhaust pipe. If needed, cut a
second hole for the air intake pipe (see
Appendix E: Combustion Air Supply ) .
3. Attach a section of pipe and clean out
tee to the flue outlet, making sure the
clean out tee is centered in the chimney
flue area.
4. Install a vented flashing at the top of the
fireplace chimney. Stainless steel plate
and screws are recommended. Cut a
hole for the vent pipe. If needed, cut a
second hole for the air intake pipe. Seal
all
joints with high temperature
waterproof silicone sealant to prevent
water leakage.
5. Seal and install vertical roof vent. If
required, seal and install a storm collar.
NOTE: THE STRUCTURAL CONDITION OF THE MASONRY CHIMNEY MUST FIRST BE
INSPECTED BY A QUALIFIED CHIMNEY SWEEP OR INSTALLER.
NOTE: YOU WILL NEED A PIPE LENGTH EQUAL TO THE CHIMNEY HEIGHT FROM THE
HEARTH. IF OUTSIDE COMBUSTION AIR IS TO BE USED, YOU WILL NEED A PIPE
LENGTH SUPERIOR FROM 12 TO 18 INCHES (30 TO 46 CM) OF THE CHIMNEY HEIGHT
TO ENSURE A PROPER STOVE BEHAVIOUR.
12”-18”