EnerSys OLDHAM GS, Инструкция по эксплуатации

Страница: 6 / 11

6
Replacing the main bulb
1. Lift reflector out of housing, making sure not
to break the bush connection.
2. Unscrew reflector from bush by holding bush
and unscrewing reflector.
3. Remove main bulb.
4. Place the new main bulb in the reflector.
5. Hold the bush and screw the reflector onto it.
Replacing secondary bulb
1. Remove bezel ring (use Remove bezel ring
procedures).
2. Remove reflector from headpiece housing.
3. Unscrew secondary bulb from side socket
assembly of headpiece housing.
4. Thread the new secondary bulb into the
socket assembly (do not over-tighten).
5. Place the hole in the reflector over the
secondary bulb.
6. Reassemble the glass (lens) and bezel to the
headpiece assembly.
Replacing the reflector
1. Remove the bezel ring and lens.
2. Remove the reflector from main bulb bush
connection.
3. Remove gasket around reflector.
4. Place the gasket around the new reflector.
Ensure the gasket is in place all the way
around reflector.
5. Thread the reflector onto the bush connection.
6. Reassemble the lens and bezel ring (see
Reassembling of bezel ring).
Reassembling the bezel ring
When the lens is in position over the reflector, the
bezel ring is locked in position by a hex headed
lock screw that fits into a countersunk hole and
then enters one of the slots in the bezel ring. The
countersunk hole enclosing the lock pin can be
filled with wax if desired.