EnerSys alpha CXPS-E3, Руководство пользователя

Страница: 19 / 64

9400016-J0 Rev E 18
User Guide CXPS-E3
4.4.6 Network connection and remote communications
The system can be set up, monitored, and tested via an Ethernet 10/100 Base-T serial data connection. The
communication protocol supports a web interface. A CAN bus is used to transmit all alarm and control functions
between the controller and rectifiers.
Refer to
Cordex HP System Controller Software Manual (0350058-J0) for operation of controller.
4.4.7 Front panel wiring notes
The terminal blocks on the indicator boards are suitable for #26-16AWG wire. As both signals are low current, it is
recommend to use thinner wire were possible to make routing easier and to minimize space consumed by in the
system. This is especially important with the L-ADIO if many of the expansion IO capabilities are to be used.
Added wiring should be routed along the same path as the bus connection cable and then extend through the
back of the unit. Take care to restrain the wiring sufficiently while providing enough slack so as not to interfere
with operation of the door. Use the cable tie locations on the L-ADIO to restrain the cables within the front panel,
and use the lance features on the chassis side panels to guide the cabling to the back of the unit.
Figure 9 — L-ADIO IO peripheral
CAN Ports
CAN Ports
Power Input
Bus B Alarm
Bus B Voltage
Bus A Alarm
Bus A Voltage