EnerPro EPA1050, Инструкция по установке и эксплуатации

Страница: 55 / 58

EPA Series - Installation and Operation Manual
55 EnerPro Boiler-EPA Series- IOM
Warning
This installation must conform to the requirement of the
authority having jurisdiction or, in the absence of such
requirements, to the National Fuel Gas Code, ANSI Z223.1/
NFPA54 , and/or Natural Gas and Propane Installation
Code, CAN/CSA B149.1.
Warning
For Direct Vent Application the wall thickness shall be
minimum 2” and maximum 24”.
Warning
If you do not follow these instruction exactly, a fire or
explosion may result causing property damage or personal
injury or loss of life.
Warning
To assemble air intake after cleaning or service use
proper sealing material to ensure air tight also install
end elbow and mesh.
Warning
The flue gas vent pipe must be airtight and watertight.
Horizontal sections of the venting must slope downward
towards the boiler ½” per linear foot [12mm] and adequate
vent support must be provided.
Warning
Label all wires prior to disconnection when servicing
controls, wiring error can cause improper and dangerous
operation. Verify proper operation after servicing,
Warning
For Category II &IV :
combustion air provided within the boiler room, the air source
must be sized in accordance to national codes CSA B149 &
ANSI Z223.1 or local codes having jurisdiction, more than
one source may be required. The vent terminal locations
follow local and national codes requirements. The vent
terminal shall discharge flue gases away from the building
structure so that the flue gases do not cause damage to
the building, the vent terminal locations must also follow
CSA B149 & ANSI Z223.1.
For Instruction on vent installation refer to Security
Chimney, Installation manual or other Stack manufacturer
which their products meet UL1738 &ULC S363
For your safety
not Store or use Gasoline or other flammable Vapors
and Liquids in the Vicinity of this or any other Appliance.
OPERATING INSTRUCTIONS
A. THIS APPLIANCE HAS A DIRECT IGNITION SYSTEM
EQUIPPED, CONSULT MANUAL. This appliance is
equipped with an ignition device, which automatically
ignites the main Burner Do Not attempt to ignite the
main Burner by hand.
B. BEFORE OPERATING THIS APPLIANCE PERFORM A GAS
LEAKAGE TEST ON ALL GAS PIPING.
WHAT TO DO IF YOU SMELL GAS: *
Do not try to ignite or light the appliance.
* Do not touch any electrical switch. Do not use any
Telephone in the building.
* Immediately call the gas supplier from another location.
Follow gas supplier’s instructions.
* If you can not reach the gas supplier, call the fire
department.
C. Use only your hand to turn the main gas cock valve
open, never use tools. If the valve will not turn by
hand. Do not repair it , call a qualified gas service
technician. Forced or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician