©
©
1995-2021 Energy Saving Products Ltd.
1995-2021 Energy Saving Products Ltd.
www.hi-velocity.com
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage
or blindness. Never operate the HEPS System out of the ductwork. Avoid touching the glass portion of the lamp with your hands.
Fig. 6
Changing the Filter
1.
UNPLUG THE POWER CORD FROM THE HEPS UNIT
2.
Remove door by twisting the two locking cam latches
so that they are vertical to the short edge of the unit.
(Fig. 6)
3.
Remove the door at an angle, from the cam latch side
first.
(Fig. 7)
Locking Cam
Latches
Changing the UV Lamps
1.
UNPLUG POWER CORD FROM THE HEPS UNIT
2.
Remove door as described previously.
(Figs. 6,7)
3.
Remove inside module from outer cabinet.
(Fig. 11)
4.
Unplug UV lights, loosen retaining cam latches, and
remove lamp(s).
(Figs. 12, 13)
Loosen Retaining
Cam Latch
4.
Remove old filter and replace with new filter. Make
sure airflow arrow on filter is pointing to the inside of
module.
(Fig. 8)
Fig. 8
Fig. 7
5.
Replace door by inserting the flange of the door into
the filter side of the cabinet.
(Fig. 9)
Fig. 9
Fig. 10
6.
Close the door at an angle. Twist the 2 locking cam
latches such that they are horizontal to the short edge of
the unit.
(Fig. 10)
Fig. 13
Fig. 11
5.
Slide new lamp into the module.
(Fig. 14)
Tighten
retaining cam latches (finger tighten ONLY or lamp may be
damaged. Plug the ballast connector back on to the lamp.
6.
Replace door as described previously.
(Figs. 9, 10)
Fig. 14
WARNING: Never touch broken lamp or
internal contents of lamp. The lamp contains
mercury.
Unplug
UV Lights
Fig. 12
-7-
-7-
