(230-240 volt AC, 50 Hz). The machine can be connected to any power outlet that is protected by a 10
amp fuse.
Note:
Use a residual current protection device with a residual current of no more than 30 mA.
Motor on (fig. B2)
Press button (1) and hold.
Lift lever (2) and release button (1).
Motor off (fig. B2)
Release lever (2).
Attaching catch bag
*
(fig. B3)
Lift protective flap (P). Hang catch bag (1) with the hooks on both bolts
* *
of the side elements.
Maintenance
Important! Disconnect from power supply before performing maintenance and cleaning.
Clean the machine without water after each use. Please note: the air intake slots the electric motor must
be freed from grass and moss accumulations!
Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working condition.
• Check the grass catcher frequently for wear or deterioration.
• Replace worn or damaged parts for safety
Be careful during adjustment of the appliance to prevent entrapment of the fingers between moving
blades and fixed parts of the appliance.
Do not spray machine with water.
Store machine in a dry room.
ELECTRICAL SAFETY
Your mower should always be switched off at the mains before disconnecting any plug and socket
connector or extension cables.
Note:
Do not wire an extension cable directly into your mower yourself. Instead, take your mower to your
nearest Performance Power service agent. Increased safety can be obtained by having a qualified
electrician install a high sensitivity (30mA) circuit breaker in the house wiring. If you do not have such a
circuit breaker installed, or you do not wish to have one installed, then we strongly recommend that the
electric power to your rake be supplied through a high sensitivity residual current device (RCD). The
RCD is designed to provide a high degree of personal protection against harmful electric current
should fault conditions occur.
Warning!
The use of an RCD or other circuit breaker unit does not release the operator of your rake
from the safety instructions and safe working practices given in this manual.
The appliance is not intended for use by persons(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety
Children should be supervised to ensure that they do not play with the appliance.
TECHNICAL DATA
Model number
HT6625
Rated voltage (V)
230-240V~ 50Hz
Rated power (W)
1200
No-load speed (min
-1
)
4500
Cutting width (mm)
340
Working height (mm)
-3, 4, 8
Sound pressure level dB(A)
79
Sound power level dB(A)
93
Vibration (m/s
2
)
1.07
Net weight (kg)
13.50
