Energizer eZV3200P, Руководство пользователя

Страница: 37 / 54

30
3. Remove the foam filter.
4. If the foam element is dirty, clean it in warm soapy water, rinse, and allow it
to dry thoroughly, or clean in non-flammable solvent and allow to dry.
5.
Dip the foam element in clean
engine oil, then squeeze out all
excess oil. The engine will smoke
when started if too much oil is left in
the filter.
6. Wipe dirt from the air filter assembly
and reinstall into
the unit.
7.4 SPARK PLUG SERVICE
NOTE
DO NOT RINSE SPARK PLUG IN WATER. FOLLOW GUIDELINES AND BE
CAREFUL NOT TO OVERTIGHTEN THE SPARK PLUG.
Recommended spark plug:
BP7ES (NGK)
Check the spark plug gap and clean the carbon deposits at the bottom of the spark
plug.
TIGHTEN 1/2 TURN WHEN INSTALLING A NEW SPARK PLUG.
TIGHTEN 1/8 TO 1/4 TURN WHEN RE-INSTALLING AN OLD SPARK PLUG.
1. Remove the air filter access panel.
2. Remove the spark plug cap.
3.
Remove the spark plug with the
spark plug spanner.
4.
Visually inspect the spark plug.
Replace with a new one if the
insulation is cracked or chipped.
Clean with a wire brush if the spark
plug is reused.
5.
Measure the spark plug gap with a
feeler gauge. The normal value is:
0.6-0.7mm (0.024- 0.028in). Adjust
the gap by carefully bending the
electrode.
6. Carefully reinstall the spark plug by
hand, to avoid cross-threading. A
new spark plug should be tightened
1/2 turn with a spanner. A used
spark plug should be tightened 1/8
Filter
0.60-0.70mm
(0.024-0.028in)
Filter
0.60-0.70mm
(0.024-0.028in)
Filter
0.60-0.70mm
(0.024-0.028in)