16/28
Phase
Red LED
Green LED
END CHARGE
ON CHARGE
Phase 1
On
Off
Phase 2
On with short flashing
Off
Phase 3
On
On with short flashing
Phase 4
On with short flashing
On with short flashing
Phase 5 + Phase 6
Off
On with short flashing
End of charge
Off
On
When using the CG mode, the red LED is always on, while the green one is always off.
When using the remote display with a two-colour LED (AUX F – Pin 1 and 2), the following signals are
valid:
Phase
Red LED
Green LED
Yellow LED
Phase 1
On
Off
Off
Phase 2
On with short flashing
Off
Off
Phase 3
Off
Off
On
Phase 4 + Phase 5 + Phase 6
Off
On
Off
End of charge
Off
On
Off
S/S or alarm
Off
Off
Off
According to the charging curve you set, some phases may be missing.
You can use the MODE button in 2 ways:
1. By pressing and holding it (for at least 1 second): this means ENTER (Confirm)
2. By pressing it briefly (for less than 1 second): this means ROLL (next)
The multi-charger can only be programmed when no battery is connected.
If a battery is connected, it will work with the settings you used last time.
If the multi-charger is programmed in CG mode and your battery is connected the moment you start
the charger, it will resume the previous charge from the interruption point.
If the previous charge was completed, the charger will go into an idle state and “BAT” will be displayed.
Setting:
1. Turn on the multi-charger without pressing the MODE button. The unit enters the programming
mode with CB or CG displayed on the LED display to enable working mode selection.
2. Briefly press the MODE key (ROLL) to select the one you need:
• Select CB standard to perform the standard battery charge profile.
• Select CG to dislodge batteries.
3. Press and hold the MODE key (ENTER) to confirm.
4. If you have selected CG mode, follow the steps under the chapter ‘CG mode’. If you have selected
CB mode, follow the steps under the chapter ‘CB mode’.
