15/28
6.2.
Operating instructions
Please see chapter 7 for the daily maintenance schedule.
If any of the following occurs while using the multi-charger, stop using it immediately by
unplugging the power cord.
• Smoke and/or fire
• Burnt smell
• Inflation of the housing of the multi-charger or battery
1. Visualisation front
1. LED screen
2. Small LEDs indicating the value
3. LED light showing that the charger is charging
4. Small LEDs indicating the value
5. LED light showing that the charger has stopped
6. Push button to make selections
MODE
END CHARGE
ON CHARGE
Ah
A
t
V
1
2
3
4
5
6
1. Set the charger’s turning knob to ‘on’.
2. As soon as you start the charger, the digital LED screen
will show the following parameters:
• The battery voltage (two-colour LED, upper)
• The current supplied by the charger (bottom
two-colour LED, red)
• The time
• The Ah that the charger provides (bottom two-colour
LED, green)
3. In CAN bus mode only, pressing the MODE button once
will fix the configuration of the parameters and retain
the last value displayed.
4. Pressing the MODE button again, allows you to change
the parameter sequence.
5. During CG mode, pressing the MODE button will pause
the charge or desulphation.
6. Pressing the button again will restart the charger from
the last point where it stopped.
If you removed the battery, the charger will reset and
will need to be configurated again.
7. If you wish to switch off the multi-loader completely,
turn the turning knob to ‘off’.
MODE
Ah
A
t
V
