NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
3
2
•
•
-
-
-
-
•
Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.
Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or
turn off the circuit breaker.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CAUTION:
The fixture body is one piece. Do not disassemble it.
This downlight can be used with most dimmers that operate on a 0-10v system.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time:
15 minutes
•
•
•
•
1. Locate the Driver Compartment access panel (B) and
remove the screw to open the access panel, set
screw aside.
1
www.energeticlighting.com
www.energeticlighting.com
A
Fixture
1
B
Driver Compartment Access Panel
1
C
Safety Anchor Points
4
Part
Item Name
Qty.
PACKAGE CONTENTS
HARDWARE
SAFETY INFORMATION
SAFETY INFORMATION
SAFETY INFORMATION
PREPARATION
INSTALLATION INSTRUCTIONS
A
A
B
AA
Wire Nut
Qty. 5
C
B
(Rear side of fixture)
