4
5
This fixture is warranted to perform free from defects for three years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
3. Pass the entire fixture above the suspended ceiling
grid and align the fixture so that the perimeter of the
front lens sits flush and secure on the T-grid lip. Fold
out each of the 4 safety anchor points (C) and loop
safety wires through each anchor and secure to
building structure.
3
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or
cleaners containing abrasive agents. When cleaning the fixture, make sure the power is
turned off, and any liquid spray should be applied to the cleaning cloth and not sprayed
directly onto the fixture itself.
www.energeticlighting.com
Printed in China
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Circuit breaker trips
when light is turned on.
1. Power is off.
2. Incorrect wire connection.
3. Defective wall switch.
Crossed wires or power
wire is grounded out.
Verify wires are correctly
connected.
1. Check circuit breaker
or wall switch.
2. Check wire splices.
3. Replace switch.
A
C
4. Connect the fixture wires to the supply wires - black
to black (Line), white to white (Neutral), and green to
green (Ground).
If dimming will be enabled, connect the gray and
purple wires to the supply dimming leads as well.
Once wire connections are made, secure each with a
wire nut (AA). Replace the Driver Compartment
access panel and secure the panel with screw.
4
A
AA
2. Route building supply wires through access panel (B)
knock out and secure conduit to access panel with
adapter (not supplied).
2
B