18V COMBI DRILL ENE456COM
CHARGING PROCEDURE
1. BEFORE USING THE CORDLESS DRILL
If the machine is new, the battery must first be charged.
A new battery or one which has not been used for an extended period achieves full performance only after few
times charging and discharging cycles.
Attention!
After storing for a long time, the battery capacity will be reduced.
A substantial drop in operating period per charge indicates that the battery is worn out and must be replaced.
Warning!
The charger and battery pack are specifically designed to work together so do not attempt to use any other
devices. Never insert or allow metallic objects into charger or battery pack connections because an electrical
failure and hazard will occur.
2. TO CHARGE THE BATTERY PACK
The power voltage supply must conform to that specified on the rating plate of the charger.
Always inspect the battery charger, cord and plug for signs of damage before use.
Connect the battery charger to the power supply and the green light will illuminate. Then, fully insert the
battery pack into the charger to make the connections and the red light will illuminate to show charging has
started. A discharged battery at normal ambient temperature will take approximately 3-5 hours to reach full
charge. Unplug the charger, and then remove the battery pack.
ALWAYS disconnect the charger from the power source when it is not in use.
Note:
Green Light = power on
Green Light+ Red Light = Charging
Warning!
When battery charge runs out after continuous use or exposure to direct sunlight or heat, allow time for the
tool to cool down before re-charging to achieve the full charge.
3. TO REMOVE OR INSTALL BATTERY PACK
Locate battery pack release buttons on side of battery pack and depress both of them to release battery pack
from the drill.
To insert the battery pack into drill’s battery port, simple push and slight pressure will be sufficient.
