18V COMBI DRILL ENE456COM
9. BIT STORAGE
The backup bit can be placed in the storage area temporary
during working. Just push the bit into the slot. (Fig.8)
10. LEVEL DRILLING
The bubble level recessed in the motor housing on top can
keep the drill level during horizontal drilling operation. The
bubble level recessed in the motor housing on back of the
drill can keep the drill level during vertical drilling
operation.(Fig.9)
11. DRILLING
When drilling hard smooth surfaces, use a center punch to
mark the desired hole location. This will prevent the drill bit
from slipping off center as the hole is started. Hold the tool
firmly and place the tip of the bit at the point to be drilled.
Depress the switch trigger to start the tool. Move the drill bit
into the work-piece, applying only enough pressure to keep
the bit drilling. Do not force or apply side pressure to
elongate a hole.
Warning:
Tungsten carbide drill bits should always be used for
concrete and masonry. When drilling in metal, only use
HSS drill bits in good condition. Always use a magnetic
bit holder when using short screwdriver bits. When
screw-driving, apply a small quantity of liquid soap or
similar to the screw threads to ease insertion.
12. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains
nickel-cadmium batteries. Consult your local waste authority
for information regarding available recycling and/or disposal
options. Discharge your battery pack by operating your drill,
then remove the battery pack from the drill housing and
cover the battery pack connections with heavy duty
adhesive tape to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the components.
Fig.8
Fig.9
