29
EG-PMS2-WLAN PROGRAMMABLE WLAN
SURGE PROTECTOR
All brands and logos are registered trademarks of their respective owners
On the
LAN settings
page (see Figure #12 above) you can set up
DHCP, IP address, Subnet mask, Gateway, DNS server and IP filter (up
to 3 IP addresses can then be enabled for remote access).
The new settings will be applied immediately after you press the
Apply
button.
IP address, Subnet mask, Gateway, DNS server
will be used only if
the
DHCP
option is disabled.
If you set
DHCP
option it is recommended for your own convenience
to set up your DHCP server so that it always provides the same IP
address to EG-PMS2-WLAN. To do that you will need to know the MAC
address of EG-PMS2-WLAN. It can be found on this page or on the
bottom sticker of the device. The MAC address is fixed and cannot be
changed.
DNS server address
is important to be properly set up in case you
wish to enable the NTP timer correction option (see section 4.6 below).
IP filter
option is needed to prevent unauthorized access to the server.
It restricts the web server access from any computer with IP address
different from IP1, IP2 and IP3. Make sure that you input IP1, IP2, and
IP3 correctly before enabling this option.
Power Manager client port
is used for connecting with the Power
Manager software, normally it is not needed to change this setting.
Network mode
can be AP mode (device is connected to the wireless
router) or Ad-Hoc mode (device might be connected to another WLAN-
enabled device in this mode).