Enerdrive MagnaSine ME AGS, Руководство оператора

Страница: 7 / 20

©2010 Enerdrive Pty Ltd 7
3. Installation
Installing the AGS Controller
In most cases, the Auto Gen Start (AGS) Network System with Inverter and Remote
has been installed by the coach manufacturer.
1. Determine a suitable location to mount the Auto Gen Start (AGS)
Controller. It must be located in a clean, dry and protected place.
The controller can be mounted in any direction; however, allow ample room
to access the adjustment dials and to view the LEDs for troubleshooting.
Wiring is much easier if the controller is mounted within easy access to the
generator’s remote wiring. Pre-drill the four 1/8” holes if necessary.
2. Remove the 8 pin connector from the controller by pulling it straight out.
Wire the controller according to Figures 3 and 4 (see pages 8 and 9).
3. Use the four 8x3/4” screws (provided) to mount the controller to the coach’s
wall.
4. When all of the wiring is complete, plug the 8 pin connector back into the
AGS controller.
5. Connect the AGS Controller’s “NETWORK” port to the inverter’s “NETWORK”
port using the 4 wire twisted pair cable.
Figure 2 - AGS Controller, Sensor and Remote
REMOTE
CONTROLLER
SENSOR
CABLE